Small Soap Mold (Without extrusion board)

The set includes the main body and a saucer.
(Without extrusion board)

Heart: approx. 70 g
Flower approx. 74g
Hexagonal approx. 77g
Oval: approx. 82g

The shape itself is cute, so simply pouring soap into it will look great.
We recommend that you add a soap stamp (sold separately) to the design to further enhance the design!

We hope you will try our soap molds, which will make your soap making even more fun.

【How to use】 ※Please refer to the picture below.

(1) Turn the main body upside down, bottom side up, and cover with plastic wrap, making sure to adhere as tightly as possible since PLA resin tends to make the plastic wrap stick.

(2) Place the plastic wrap-covered side of the machine on the receiving tray.

(3) Pour in the soap and keep warm.
After warming is complete, wait until the soap hardens firmly.

(4) Place the extruder in a container that is taller than the mold.
　(If you are careful when removing the mold, you can push the extruder by hand to remove the mold without using a container.)

(5) Place the main body containing soap on (4) and push it downward.

■ Material / PLA Filament

■ Color / White

■ Size / Please refer to the product photos.

・After unmolding your soap and allowing it to dry for a few days.
　The best condition is neither too soft nor too hard.
(The speed at which soap dries out depends on the recipe and humidity.）

・After use, soak in warm water for several hours and then wash gently with a fine brush.

・This product is made using a 3D printer. Therefore, you may notice surface irregularities, small holes, or thin strands of PLA resin, but these are not defects.
If you are concerned about such details, we recommend refraining from purchasing to avoid any issues.